Rewinder Motor Electrical warm Other potential parts associated: Main PCA

Rewinder Motor Electrical warm Other potential parts associated: Main PCA

1. 1

   Remote troubleshooting (call agent) Switch the power off and disconnect the power cord. Open the Front Window and the Roll cover and check for any visible obstacles restricting the movement of the Rewinder Motor. If there is a wrinkled mass of Substrate inside the Carriage path, clear the obstruction. Check Substrate weight is not heavier than printer specs. Reconnect the power cord and power on the printer. If the problem persists, the call agent should arrange a service engineer visit. Onsite troubleshooting and solution (service engineer) Remove covers and check that the cables from the Rewinder located in the MPCA Board are correctly connected and not damaged. IMPORTANT: If any cable is disconnected then reconnect it, and power on the printer again to check whether the system error has disappeared. If any cable is damaged, then replace the Rewinder Motor Station assy. ·Rewinder Motor Station assembly Make sure that the Rewinder path is clear. Remove any visible obstacles (screws, plastic parts, etc.) restricting the movement of the Rewinder Motor. Go to the Service Menu (see Entering the Service Menu for Service Engineers on page 315) and run the Rewinder Motor Test to verify the Rewinder motor and replace it if needed. See 4.20 Rewinder Motor Test on page 350. If the problem persists, replace the Main PCA, see Main PCA (2Y9H0-67016, 2Y9H1-67015, 2Y9H2-67002, 2Y9H3-67003) on page 517. ·Main PCA. System error: