Feed Motor Electrical warm Other potential parts associated: Main PCA

Feed Motor Electrical warm Other potential parts associated: Main PCA

1. 1

   Remote troubleshooting (call agent) Switch the power off and disconnect the power cord. Remove the Front Window and check for any visible obstacles restricting the movement of the Feed Motor. If there is a wrinkled mass of Substrate inside the Carriage path, clear the obstruction Check Substrate weight is not heavier than printer specs. Reconnect the power cord and power on the printer. .If the problem persist the call agent should arrange a service engineer visit. Onsite troubleshooting and solution (service engineer) Remove covers and check that the cables from the Feed Motor located in MPCA board are correctly connected and not damaged. IMPORTANT: If any cable is disconnected then reconnect it, and power on the printer again to check whether the system error has disappeared. If any cable is damaged, then replace the Feed Motor Station assy. · Feed Motor Station assembly Make sure that the Carriage path is clear. Remove any visible obstacles (screws, plastic parts, etc.) restricting the movement of the Feed Motor Go to the Service Menu (see Entering the Service Menu for Service Engineers on page 315) and run Paper Motor Test to verify the Feed motor and replace it if needed. See 4.18 Paper Motor Test on page 347. If the problem persists, replace the Main PCA, see Main PCA (2Y9H0-67016, 2Y9H1-67015, 2Y9H2-67002, 2Y9H3-67003) on page 517. ·Main PCA System error: